About Huaxin

GPIO OTP

HS23P1800
HS23P1800 is 8-bit MCU with low power consumption, high speed, high noise tolerance and OTP program memory. RISC has a total of 42 instructions, except that the branch instructions are two-cycle instructions, the rest are single-cycle instructions.

Product overview

HS23P1800 is 8-bit MCU with low power consumption, high speed, high noise tolerance and OTP program memory. RISC has a total of 42 instructions, except that the branch instructions are two-cycle instructions, the rest are single-cycle instructions. This easy-to-use, easy-to-remember instructions greatly reduce the development time. HS23P1800 includes power-on Reset POR, Brown-out Reset BOR, power-up Reset Timer PWRT, Oscillator Start up Timer OST, Watchdog Timer, EPROM/ROM, SRAM, 3-state I/O port (can be set to pull-up/pull-down, open drain), Power-saving sleep mode, 8-bit timer/counter with 8-bit preset, 3-channel PWM outputs, independent interrupt, sleep wake-up mode and reliable code protection, there are two oscillating sources available for user configuration, including a power-saving oscillating source and a low-power oscillator. HS23P1800 can access 1K×14 program storage space, it can directly or indirectly access registers and data storage area, all special function registers distributed in the data storage area contain specific program Pointers.

Product details

◆ 42 RISC instructions, all instructions are single cycle, except program branch instructions are two cycles

◆ 14-bit wide instruction, 8-bit wide data path, 5-level deep hardware stack

◆ GOTO/CALL instruction load 10-bit PC address directly

◆ 1K×14 program memory

◆ 65 x 8 bit general-purpose register

◆ Operating speed: DC-20 MHz clock input; Dc-100 NS command cycle

◆ Direct and indirect addressing

◆ Two 8-bit real-time clocks/counters of 8-bit programmable prescaler (Timer0)

◆ 3 PWM outputs, 1 BUZ Internal power reset circuit (POR), built-in low voltage detection

◆ Power-on reset (POR), low voltage detection (LVD)and brown-out reset(BOR)

◆ Watchdog timer (WDT) with high reliability of internal crystal,enabled or disabled by software

◆ One group of I/O ports IOB adopts independent command control and can be configured with pull-up, pull-down and open-drain states

◆ Wake up sleep: INT pin or port B input state changes to wake up 

◆ Power saving sleep mode, programmable code protection

◆ IRC: internal high speed RC oscillator 

◆ Wide operating voltage range: 2.2V to 5.5V